As we clean up the engine and get ready to put the crankshaft back in, there
are two pieces that were damaged by a PO but do not seem to be available for
purchase - the sealing block and the rear oil seal housing (#s 116 & 96 on pg.
58 in the Haynes book) Does anyone know of a replacement source? The part
that was damaged were the screw holes on the bottom - our other alternative
seems to be getting the holes filled/retapped - does anyone have experience
with this?
Thanks!
Kirsty
78 Midget
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|