Has anyone had any experience with the reamer Moss sells for enlarging the
throttle spindle hole in SU carbs? I believe it opens up the hole .015 inch
in order to fit the oversized spindle. This would work fine for small wear
problems, but what about bigger problems? Is there a procedure to fit
bushings? I know a machine shop would take my $$$$ and do something like
that, but I was thinking about something I could do in the garage.
Bob in Kansas
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|