A more controlled way of pressurising the master is to get a bicycle
inner tube, cut it in half. One end goes over the open master cylinder
top, fastened with a tight rubber band. Opposite end folds over 2 or 3
times to seal it and fastens with a second rubber band or bulldog
clip.
You now have what is technically known as a Monty.
Now Pump up the Python it with a few strokes of an ordinary cycle pump
and then get under and bleed that valve. Just mind the m/c dosn't run
dry.
Guy
----- Original Message -----
From "Frank Clarici" <spritenut at Exit109.com>
To: "Jurgen de Haan" <jdh@elscolab.nl>
Cc: <spridgets@autox.team.net>
Sent: 05 March 2002 03:37
Subject: Re: Clutch Bleeding
> Jurgen de Haan wrote:
> >
> > Hello list,
> >
> > After trying to bleetch the clutch for one month now spoiling a
lot > of silicone fluid it is still not possible to use the clutch.
>
> I have found you have to pressure bleed the clutch with silicone
fluid.
> 20-25 PSI seems to work best.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|