In a message dated 11/12/01 6:36:05 PM Eastern Standard Time,
nosimport@mailbag.com writes:
<< To ease the job a bit, I've used a scissors jack to support the pan whilst
getting the screws tight. >>
Much easier to have the engine out of the car and up side down on your
kitchen counter. I just let gravity do the work for me.
As I was installing the distributor drive, I was have some kind of dyslexia,
"Is the large offset supposed to be upper most or lower most?" "Should that
be twenty to two, or twenty after ten?" Finally I just turned the manual
upside down. It was either that or stand on my head.
I must say though, putting the head is going to be a bitch.
David Oliner
60 Bugeye
67 TR 4A
PS Thanks to everyone for your advice.
|