Hello DLancer7676,
Saturday, September 08, 2001, 8:17:38 AM, you wrote:
Dcc> In a message dated 9/7/2001 11:50:20 PM Eastern Daylight Time,
Dcc> w.gilroy@verizon.net writes:
>> All of these parts were replace about 1K ago. It seemed a bit
>> fast to pit the points. The wire I am not sure why I had carbon
>> traces. The real question is why did the center post in the dizzy
>> just get burnt away in such a short period of time? Any ideas.
>>
Dcc> You know, I noticed last week that the rotor in my "79s dizzy seemed to be
Dcc> burnt on the end. I checked the inside of the dizzy cap and it seemed to
be
Dcc> fine.
The end of my was fine. It was the center where the spring load rod
from the coil that was burnt.
--
Best regards,
Bill mailto:w.gilroy@verizon.net
|