Good morning listers,
With a new daughter about to take up most of my spare time there's a new
urgency to get my Sprite MOT'd !
The main area of concern now is the brake piping for the single circuit brakes.
Some of it was incomplete when I bought the car. My questions are:
1/ Can anyone describe exactly how front brake pipe runs from the brake unit,
across the front chassis member to the union ? There should be two clips
securing the pipe but I do not see any holes which can be used to secure the
clips. I'd like to know where these ought to be before I drill holes for them.
2/ The front-to-rear pipe runs through transmission tunnel but with no obvious
clamping in sight. What clamps should be used in practice and is this a
propshaft out job ?
3/ I'd still like to know where to drill the holes in my floor to fit the organ
accelerator pedal. Someone kindly sent me some dimensions previously but these
were for a LHD bugeye not a later RHD Sprite. Anyone got some measurements?
Thanks in advance,
Louis Mehr
Manchester, UK
1971 AH Sprite RHD- now running (sort of)
|