Bill,
Since you have the mounting position on the tunnels side, you could drill a
hole in the correct location on the rocker side and weld a nut to the inner
sill. You could either plush mount it or weld the nut to a small plate with
a hole large enough for the nut to fit though and then wekd the plate to
the sill. I have specs on the correct location if you need them.
Gerard
At 7:13 AM -0700 7/10/01, BILL wrote:
>I'm trying to put seat belts in my Sprite. Problem is the PO (DPO in this
>case) put new rockers in but there is no threaded "nut" on the rocker side
>for the seat belts. Any ideas on how and where to mount this side? My only
>thought so far is to drill through the floor.
>
>Herby
>64 MK II Sprite - HRBYTOY (under construction/de-construction)
>62 MK II Sprite - HRBYTOY2? (My new driver)
>billh@aaai.com
>www.herbytoys.com
>
>(P.S. thanks for the info on my Weber problem. I'm going work on that this
>week)
--
Please visit Four Points Travel -
Discount Online International Travel Reservations
http://www.gerardsgarage.com/fourpoints
To make a reservation please call Toll Free 1-800-272-3253
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
|