Because the pipe going into the MC points 'down'. You would really have to
have the front end of the car up high to get the line to be level.
Robert D.
-----Original Message-----
>Spridgeteers -
>
>When I removed my clutch slave cylinder last week, it ended hanging
>straight down from the flex hose. That reminded me of my experience
>re-assembling the front disk brake system on my Harley FX. Since the
>caliper (cylinder) was approximately straight down from the master cylinder
>mounted on the bar, I just topped up the MC and tapped the line and caliper
>to get the bubbles out. Did not use the bleed fitting. After setting for
>a couple of hours with occasional tapping, I put the lid back on the MC,
>and had a hard brake. Can anyone think of a reason why this wouldn't work
>on the Sprite clutch slave?
>
>Clay L.
>'67 Sprite
|