Re: prime and paint

In a message dated 4/13/2001 8:56:25 PM Eastern Daylight Time, 
jdagostino@mediaone.net writes:


> I usually finish with 600 grit wet, then wash down with water and a sponge
> or wet cloth

Not recommended to use wet-sanding and water wash if you have used a 
fill-type primer, or a spray can primer, which absorbs water like a sponge.  
Fine if you are using a sealer type primer like epoxy or one of the two part 
primers.  

--David C.

///
///  (If they are dupes, this trailer may also catch them.)