Phil,
Do you know if it has the locating rings for the head? I have a manifold
that fits that description, but does not have the rings, so it's hard to
position.
Gerard
At 10:29 AM -0500 4/10/01, Phil Vanner wrote:
>APT www.aptfast.com sells HS4 manifolds for the A-series. Part number SUA4-2
>is the one for Spridgets (carb sits at a 20 degree angle like a stock
>manifold.) at $179 it's pricey, but they maintain that it flows much better
>than a B manifold. (this not at all like the manifold on Dan's car)
>
>No provision for vacuum take-off however.
>
>Phil Vanner
>61 Midget
>
>-----Original Message-----
>Hello Dan,
>
>Monday, April 09, 2001, 1:13:45 PM, you wrote:
>
>DD> No bubbles needed as long as you use the correct
>DD> manifold rather than butchering a B intake.
>
>
>In all fairness ours are for a 1500 and uses the stock manifold. Tim
>modified a B manifold to fit a 1275. Not sure about how high it
>sticks up.
>
>--
>Best regards,
> Bill mailto:w.gilroy@verizon.net
>
--
Please visit Four Points Travel -
Discount Online International Travel Reservations
http://www.gerardsgarage.com/fourpoints
To make a reservation please call Toll Free 1-800-272-3253
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
///
/// (If they are dupes, this trailer may also catch them.)
|