An efficient way to get the old motor oil on the parts is to mix it (50-50) with
kerosene, then spray on with a plastic pump bottle. The kerosene tends to
evaporate more quickly, leaving the oil residue. Lasts for quite a while, and
it
gets the oil applied thoroughly.
"Vrba, Dave" wrote:
>
> What is a good way to store these types of all metal parts for future use so
> they will be ready to use when needed?
>
> I just cleaned it up and put a light coat of white general purpose grease
> all over it and wrapped it up with shrink wrap type clear clingy stuff to
> seal it up. Spose this is OK?
> Cheers,
> David L. Vrba
> '62 Sprite MKII
> Dublin, CA
///
/// (If they are dupes, this trailer may also catch them.)
|