In a message dated 3/21/2001 3:01:19 AM Eastern Standard Time,
ckotting@core.com writes:
<< If you're just putting in "Sealed Beam Halogens" (same wattage, but more
efficient) the stock wiring should handle it if it's in good condition.
If you're going for one of the higher-power types, I would put in relays
with power fed by a heavier gauge cable. >>
Even with the sealed beam halogens the relays will (as I understand it)
provide more power to them so that even they run brighter, and are a lot more
dependable. Plus, if you are at a point where making this addition is
feasible, it is preferred as it gives you the easy option to later go with
higher power lights.
--David C.
///
/// (If they are dupes, this trailer may also catch them.)
|