Jeff,
Also check out that the gasket lines up properly with the cover and DON'T
overtighten, Makes the cover into funny mating surfaces!
Paul A
FROM: "Jeffrey H. Boatright", INTERNET:jboatri at emory.edu
TO: Spridgets, INTERNET:spridgets@autox.team.net
Ron Soave, INTERNET:soavero@yahoo.com
DATE: 3/11/01 4:11 PM
Re: Re: gaskets
Ron,
Thanks, that's what was done this time, but for some reason, massive
leaks for no obvious reason.
Jeff
> > the archives. For the cork valve cover gasket,
>> should one pre-soak in
>> motor oil, or just smear lithium grease on both
>> surfaces, or install
>> dry?
>
>Jeff, I just put a tiny bead of RTV on the side that
>mates to the valve cover, let it setup for a little
>bit, then bolt it down. never had a leak, and the RTV
>makes it real clean to pop the cover off and on.
>
>=====
>Ron Soave
>"Driver Carries No Cash"
>Yahoo! Auctions - Buy the things you want at great prices.
>http://auctions.yahoo.com/
--
__________________________________________________
Jeffrey H. Boatright, PhD
Assistant Professor, Emory Eye Center, Atlanta, GA
Senior Editor, Molecular Vision
<http://www.molvis.org/molvis>
<mailto: jboatri@emory.edu>
----------------------- Internet Header --------------------------------
Received: from teamfat2.dsl.aros.net (teamfat2.dsl.aros.net
[207.173.21.42])
by spdmgaaf.compuserve.com (8.9.3/8.9.3/SUN-1.9) with ESMTP id
QAA12808
for <PAsgeirsson@compuserve.com>; Sun, 11 Mar 2001 16:11:08 -0500
(EST)
Received: (from majordom@localhost)
by teamfat2.dsl.aros.net (8.11.0/8.11.0) id f2BL17m20332
for spridgets-actors; Sun, 11 Mar 2001 14:01:07 -0700 (MST)
References: <20010311204930.4381.qmail@web1101.mail.yahoo.com>
Date: Sun, 11 Mar 2001 16:00:41 -0500
To: Ron Soave <soavero@yahoo.com>, spridgets@autox.team.net
From "Jeffrey H. Boatright" <jboatri at emory.edu>
Subject: Re: gaskets
|