GLOWNSDALE@aol.com wrote:
>
> Bill,
> Before you grind the sides off another wrench, Craftsman makes a thin and
> long 1/2" - 9/16" open end wrench that is perfect for removing and tightening
> the intake/exhaust flange nuts. I have used this wrench for over twenty
> years and it is still sold through their tool line.
> Best regards,
> Gary L
This makes sense but it is too late for me. One other thing I did was
take an open end wrench, with 1/2" and 9/16" ends, and bent it about
30 degrees in the middle. This wrench gets a lot of use on my Midget.
Gilroy
|