ok today i recieved 2 left front spindles for disc brake. they carry the
same BTA747 number cast into them....but!
1, carries BB38AX near the top of the rear side
BTA747
EN16T near center
and MOWOG near bottom of the rear of the casting
2, has a cast outline of an arrow pointing downward at the top
BTA747
D 16 near center
and A340 X near the bottom of the casting
my question is which is early and which is late and knowing where these came
from, is one of the two a stronger (special tuning dept. ) piece?
the person who had these raced for a number of years and this stuff along
with a panhard rod for 1/4 leaf spridgets and a few odds and ends were what
was left from parts he had as spares that did not go with the race car when
it was sold. these were properly stored and are rust free, even on the
back sides! the bushings in them look near new!.....
any insight out there gang?
chuck.
considering their condition, they are heading for my spares dept. in my
basement, where the"nice and neat" stuff are stored. ......... :)
|