In a message dated 9/8/2000 8:34:32 PM Eastern Daylight Time,
bmantz@roanoke.infi.net writes:
<< However, is it as inadvisable to replace a single needle bearing? The
old ones look like new, but they must be worn some, I would think. >>
Bill:
Personally, I would follow what the good book (Haynes) says about false
economy. Seems like if you have the tranny out and have dug that far into
it, it would be a false economy to not go ahead and renew all of the
bearings. So I would replace them all, just to be on the safe side.
--David C.
|