My Moss Sprite Arrow fit perfectly in the existing holes (about
three years ago).
Half the time I screw up by not researching fine point differences
between models. So I will get an exhaust clamp "wrong size", wrong
material door seals etc. etc.
Half the time its the only thing out there. Took me days to modify
an aftermarket gas tank to fit the bugeye.
Occasionally the car has had a mod or anomaly, and its far too
easy to conclude the part supplier is a dope.
And finally half the time its just plain poor quality.
Despite the frustrations, I am grateful that there are affordable
alternatives to the sometimes much bigger pain in the arse -
shopping for used junk.
Mike L.
60A,67E,59Bug
----- Original Message -----
From WFO Herb <froggi at cdsnet.net>
To: <Bkitterer@aol.com>
Cc: <spridgets@autox.team.net>
Sent: September 8, 2000 1:13 AM
Subject: Re: Sprite Arrow
> Why can't these SOB's get it right in the first place!?! Why do
we continue
> to purchase inferior parts? Send 'em back if they don't fit.
Eventually
> they'll get the message that we are NOT going to 'compromise our
standards'.
>
> Am I the only one that thinks this way?
> WFO Herb
>
>
> Bkitterer@aol.com wrote:
>
> > Mike,
> >
> > One option on the current after market arrows is to file the
edges of the
> > pins so that they fit the holes in the body. Just a thought.
> >
> > Bob and Annice
> > 1960 Sprite (Mk IV in disguise)
> > 1967 Sprite Mk III (in progress)
>
>
|