I am trying to make my Midget 1500 roughly UK
spec using bits from the UK.
Everything is fine except I am having trouble
doing the heater hose routing, I have one extra end.
Can somebody describe the hose routing in the
rear area of the block, around the heater input
and shut off faucet?
I have the following ends to connect:
- Heater outlet
- Heater inlet
- Faucet inlet
- Faucet outlet
- Block connection
- Inlet manifold top connection
- Inlet manifold bottom connection
- pipe-under-manifold rear connection
- pipe-under-manifold side connection
...and notice my dilemna, there are nine connections
to be made, so I'm going to have one extra.
Is there a Tee fitting that goes somewhere in
mid-hose?
--
Trevor Boicey, P. Eng.
Ottawa, Canada, tboicey@brit.ca
ICQ #17432933 http://www.brit.ca/~tboicey/
Only one of the three Rs actually begins with R.
|