Hi Larry,
I have a proceedure for getting stuck pistons out of frozen wheel
cylinders. Works for double or single cyls. I take bleeder and grind off
the seating end, and cut off the other end so Now it looks kile a hollow
nut. Tap the cut off top end to 1/4 28 SAE bolt size, screw a grease
fitting into it. Thread it into the bleede hole and now put a grease gun
on it and pump away. I've broken loose everyone I've needed to this way.
Cheap and simple. With a double cyl., you get out one piston, clean out
the grease, cups and springs and you now have access to the second piston
to pound it out with a soft drift and a BFH.
Good luck, Paul A
|