| To: | DLancer7676@cs.com, boxweed@thebest.net, atocci@advanta.com |
|---|---|
| Subject: | Re: Structural Repair |
| Date: | Wed, 15 Mar 2000 21:11:57 EST |
| Cc: | spridgets@autox.team.net |
David is right as far as the welding sequence, but i would also add that you use a readily available heat sink to minimize any warping. just my 2 cents worth bill r 74 midget |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Gauging wire wheel and hub wear, Unknown |
|---|---|
| Next by Date: | Re: British Car magazine, Unknown |
| Previous by Thread: | Re: Structural Repair, Unknown |
| Next by Thread: | Re: Structural Repair, Unknown |
| Indexes: | [Date] [Thread] [Top] [All Lists] |