--part1_c5.298c659.25f5f96c_boundary
--part1_c5.298c659.25f5f96c_boundary
Content-Disposition: inline
Return-path: BCAH@aol.com
From BCAH at aol.com
Full-name: BCAH
Date: Tue, 7 Mar 2000 01:15:03 EST
Subject: Fwd: bolt size - and
To: spridget@autox.team.net
--part2_c5.298c659.25f5f867_boundary
--part2_c5.298c659.25f5f867_boundary
Content-Disposition: inline
Return-path: BCAH@aol.com
From BCAH at aol.com
Full-name: BCAH
Date: Tue, 7 Mar 2000 01:12:05 EST
Subject: Re: bolt size - and
To: wizardz@toad.net
Nope, ------I just checked,----it is 5/16 X 24tpi -------------------- I
made a puller by getting a "tall" nut and threading a slide hammer into one
end and then putting the shaft into the hub and screwing that onto the
threaded stud of the greese cup. Hammer was from one of those $1.99 specials
at the grocery store. Tall nuts are sometimes used on exhaust manifolds and
are made of brass. Can also be found at hareware stores as "joiner nuts' for
connecting "All- Thread " rods. Hope this helps,----Bob Chamberlain
--part2_c5.298c659.25f5f867_boundary--
--part1_c5.298c659.25f5f96c_boundary--
|