"Charles D. Sorkin" wrote:
>
> Dear List:
>
> A couple of questions about HS2 carbs:
>
> Should the "AN" needle be completely smooth along its entire length, or
> should the top 1/2" of it be larger where it mounts to the piston?
It should have a slightly thicker shoulder where it mounts.
> Where does the needle usually wear?
Either along one side of the shaft (rubbing on the jet) or the point
itself.
> When reinstalling the needle, should it go all of the way into the piston,
> or should the ridge on the upper part be flush with the bottom of the
> piston?
Shoulder sits flush with the bottom of the piston.
> Is "AN" the normal mixture needle?
AN is the normal.
> And when reassembling, how do I split the screws that hold the throttle
> plate in place?
Carfully with a thin screwdriver. Use loctite on the screws too. You can
never be too safe.
> Which way does the bevel go on the throttle plate?
Um, isn't it beveled on the top on one side and the bottom on the other?
I don't have one in front of me.
> P. S. How do I get dashpot oil off of my computer keyboard?
Have a cat lick it up.
--
Frank Clarici
Toms River, NJ
Too many Sprites (again)
There is a very fine line between "hobby" and "mental illness."
http://www.exit109.com/~spritenut
|