Hi list & especially Ron,
Read the earlier post about swapping inlet/outlets on x-flow rads and started
to think about some x-flow options.
1. Is it possible to swap the bottom radiator inlet/outlet from the left
hand side to the right hand side and save some weight by getting rid of the
steel pipe? Or does this design cause poor water flow/cooling in the unit?
2. If the top inlet/outlet is swapped to the opposite site and the bottom
inlet/outlet swapped to the opposite side am I correct in thinking the
advantages of option 1 is gained (ie loss of steel pipe) but coolant flow in
rad is still same (albeit other way round to standard) and therefore no less
efficient? I note that a mini t'stat housing and non standard hoses would be
required along with of course a hybrid rad.
Ay comment?
Daniel1312
|