Frank Clarici wrote:
>
> Glen Byrns wrote:
> >
> > Is it a common practice to cut down the shift lever on a bugeye?
>
> I cut a few of mine down, it's pretty straight forward if you have a
> hacksaw and a tap/die set. Don't go too short.
I have cut gearshifts down before using a, ahem, faster method.
If the gearshift has a boot when installed, I just take out
a section of the middle and weld the ends together. Do it all
underneath the boot, and you are none the wiser.
You can also do the reverse, put a piece in.
--
Trevor Boicey, P. Eng.
Ottawa, Canada, tboicey@brit.ca
ICQ #17432933 http://www.brit.ca/~tboicey/
"A Noble Spirit Embiggens the Smallest Man" - Jebediah Springfield
|