spridgets
[Top] [All Lists]

Re: Near to a solution, $(*&^ Lucas

To: pasgeirsson@juno.com
Subject: Re: Near to a solution, $(*&^ Lucas
Date: Sun, 09 Jan 2000 17:02:38 EST
Cc: cdsorkin@ix.netcom.com, spridgets@autox.team.net
References: <000d01bf5a51$ddacbf80$0becdfcf@ht3zv><20000109.125414.6687.2.PAsgeirsson@juno.com>
Hi Charles,

One item should read Distributer CAP, not just distributer for spring
loaded carbon piece.  Sorry for not proofreading!

Paul Asgeirsson
9123 N Clarendon Ave
Portland OR 97203-2750
503-978-1103
PAsgeirsson@juno.com

On Sun, 09 Jan 2000 15:55:30 EST Paul A Asgeirsson <pasgeirsson@juno.com>
writes:
>Hi Charles,
>
>My experience in recent years with Lucas rotors and caps have been a 
>whole lot less than sterling.  Check to see if the spring loaded 
>carbon piece in the distributer is still there.  They pop out with 
>alarming frequency.  The cap may also be new but defective.  Rotor may 
>be rubbing its underside on something in the distributer, so look 
>closely. And if you have splitfire plugs in the car, take them out and 
>use them for fishing weights.  Echlin from NAPA is a good replacement 
>for Lucas.
>
>Paul
>PAsgeirsson@juno.com
>
>On Sat, 8 Jan 2000 22:30:23 -0500 "Charles D. Sorkin" 
><cdsorkin@ix.netcom.com> writes:
>>Dear list:
>>
>>Well, I finally have gotten (almost) my ignition system problem 
>>straightened
>>out.  I got the car running today.  For about 5 seconds.  (Hey, its 
>an
>>improvement over the previous condition).  I think I have discovered 
>>the
>>problem.  Hopefully it is the only problem.
>>
>>Among the items that I have changed, I have had two different new 
>>Lucas
>>rotors in the distributor.  Since I'm getting spark at the points, 
>but 
>>not
>>at the plugs, and the wires and distributor cap are new, what else 
>>could be
>>the problem?
>>
>>I went out and picked up a third Lucas rotor, installed it, and got 
>>the car
>>to run for another five seconds.  Took the distributor cap off, and 
>>sure
>>enough, the rotor was loose, even though it is sitting exactly where 
>>it is
>>supposed to be.
>>
>>How the hell could Lucas #(*&$ up a @#($*&ing rotor?!?!?  Its just a 
>>piece
>>of plastic that comes out of a mold!  Does this mean that all Lucas 
>>rotors
>>produced in the last batch are bad?
>>
>>A whole month of motoring wasted...
>>
>>Regards,
>>
>>Charles
>>'74 Midget
>>'68 Sprite
>>cdsorkin@ix.netcom.com
>>Bloomfield,NJ
>>
>YOU'RE PAYING TOO MUCH FOR THE INTERNET! Juno now offers FREE Internet 
>Access! Try it today - there's no risk!  For your FREE software, 
>visit: http://dl.www.juno.com/get/tagj. 

<Prev in Thread] Current Thread [Next in Thread>