spridgets
[Top] [All Lists]

Re: Sprite wheels & tires

To: spridgets@autox.team.net
Subject: Re: Sprite wheels & tires
From: Rick <rickfisk@concentric.net>
Date: Thu, 16 Sep 1999 14:18:33 -0400
References: <017f01bf0060$ea1ea300$03000004@geopro> <006c01bf0066$0b5be820$197e14c0@navtech.com>
Reply-to: Rick <rickfisk@concentric.net>
Sender: owner-spridgets@autox.team.net
A couple of weeks ago Sears had 145-13 Michelins on sale for $19.99 each.  I
bought five <g>.  Five new Michelins for $100 - what a deal!

Rick
'59 Bugeye

Curtis Carlson wrote:

> Re: Sprite wheels and tires....
>
> Did you all know that the offset for the steel wheels for Bugeyes and early
> squarebodied Sprites is different than the offset for later square bodied
> Sprites?  When I bought my car, it had 4 steel "slot ventilated"  wheels and
> one steel "hole ventilated" wheel for the spare.  The "holed" spare wheel
> and tire would never fit into my trunk with the supplied tie-down.  I just
> got my replacement "slotted" steel wheel back from the paintshop and after I
> put the tire on it, it fit into the trunk and the tie-down (bolt with large
> washer) works now.  I gave my old "holed" spare to Phil Vanner for his '62
> Midget.
>
> BTW....I'm running with Michelin 145-13's and man, they're GRRRREEEAT!!!
> I'd highly recommend them over the 155-13's I had before.....better
> cornering, closer to original, and no rubbing on the front suspension on
> those tight corners in the gymkhanas.
>
> Curt
>
> Curtis Carlson
> '66 Austin Healey Sprite MkIII ("Gerty") HAN8L-63423
> '72 MG Midget MkIII ("unnamed")
> ________________________
> Research Geographer  612.931.3936 (voice)
> Navigation Technologies  612.931.3937 (fax)
> 5780 Lincoln Dr  Ste. 100 612.251.7492 (mobile)
> Edina, MN  55436  carlson@navtech.com

--
Bugeye on TEN
NIS League Member
Sponsored by Thomas Enterprises
Makers of the TSW and TSW II Wheels
Sponsored by Beech Ridge Motor Speedway

http://www.thomas-superwheel.com
http://www.beechridge.com



<Prev in Thread] Current Thread [Next in Thread>