Having ridden with the aforementioned driver - I am not at all sure that
a swivel based cup holder would help. I do believe he just needs
something with a seal!! That will handle all types of cornering,
downshifting and hammering of the brakes at the last second. ;-)
Just wish I could go too. (Freakin work)
Larry
At this exact moment in time 8/29/99 9:57, wmgilroy@lucent.com made the
profound statement:
>
>
>Lancer7676@aol.com wrote:
>>
>> In a message dated 8/28/99 10:12:34 AM Eastern Daylight Time,
>> spritenut@Exit109.com writes:
>>
>> << Very simple...Buy one of those flexible plastic clip on the window lip
>> holders for around 1.49, cut off the window clip, paint a fender washer
>> the same color as your carpet, screw it to the center hump between the
>> seats using 1 screw and a fender washer. If you pre-punch a hole thru
>> the carpet nap it can be removed and no one will ever know it was there. >>
>>
>> Sounds technical to me Frank. Got diagrams, pics, drawings, measurements?
>> Special tools needed for the project? Alignment measurements so the "lean"
>> of the holder won't throw the suspension and steering out of alignment???
>>
>> --David
>
>Given Franks proximity to water, I am surprised he did not go with one of
>those boat cup holders, that remain level no matter how the boat pitches
>or rolls. That would have handled the extreme acceleration, deceleration
>and cornering G's that PIECES will have to handle while on the way to
>Wisconsin. You would not want WAWA coffee on the floor or driver. :-)
>
>Bill Gilroy
Larry B. Macy, Ph.D.
macy@bblmail.psycha.upenn.edu
System Administrator/Manager
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 1015 Gates
Philadelphia, PA 19104
|