Tony,
I just went out and looked at my car, but doubt this would work. The wiper
motor hits the stock air cleaner intake tube, and so it can't go high
enough. I suspect you're using a different air cleaner? But also, the way
I put the new master cyls in, they cover up two of the mounting holes. The
holes are stil there, just under the metal of the master cyl box. Did you
drill through the master cyl box, or did you mount the master cyl more to
the left than I did? Great idea, but don't think it will work on my car.
Ric
>Ric,
>I just had the same problem when I converted by bugeye to dual circuit
>brakes. I think you can retain the orginal wiper motor and mounting
>position. What you want to do is just space the motor straight up so that
>it clears the new brake cylinder mounting. Make three spacers from some
>tubing (approximately 2" ea.), buy some longer 10-32 bolts and put the
>spacer between the the wiper motor and the original mount. Use the longer
>screws in place of the orginal mounting screws. I'm still piecing my
>bugeye back together, but the motor seems to operate just fine on the new
>"stilts". Hope it works for you!
>
>Tony
|