Might have been:
http://yallara.cs.rmit.edu.au/~mg/cars/goblins/tech/webers.htm
--- "Wm. Severin Thompson" <wsthompson@thicko.com>
wrote:
> To all,
>
> Somewhere... maybe off the list or on the
> Puddlejumper set was a write up
> entitled, "Having Trouble Setting up your Weber?".
> It had all sorts of
> engine and head configurations, and the suggested
> jetting for various
> applications.
>
> Does anyone remember this and know where it can be
> found?
>
> WST
> ----- Original Message -----
> From: Ron Soave <soavero@yahoo.com>
> To: <Kroyell@aol.com>; <spridgets@autox.team.net>
> Sent: Thursday, August 19, 1999 7:40 AM
> Subject: Re: Weber Set-up??
>
>
> > > I also put on a "soft mount" kit at the same
> time,
> > > has anyone had problems
> > > relating to these kits??
> >
> > My 45DCOE came w/ the soft mount kit, and an
> extremely
> > respected mechanic friend who is a "by the book"
> guy
> > with lots of Weber experience suggested I ignore
> the
> > instructs and tighten the nuts down almost
> completely.
> > He has seen leaks and damage resulting from the
> > assembly being too loose. I do not have very long
> > term usage yet (~1 yr), but so far so good. I did
> not
> > overtighten the nuts, but did go beyond the torque
> > setting recommended in the limited instructions.
> It
> > seemed like the carb was flapping in the breeze
> too
> > much at the low torque.
> >
> >
> > Bid and sell for free at http://auctions.yahoo.com
> >
> >
>
>
Bid and sell for free at http://auctions.yahoo.com
|