To: | "HFC" <froggi@cdsnet.net>, <Lmacy1211@aol.com> |
---|---|
Subject: | Re: U-Joints |
From: | Larry Macy <macy@bblmail.psycha.upenn.edu> |
Date: | Thu, 3 Jun 1999 10:20:12 -0400 |
Cc: | "MG List" <mgs@autox.team.net>, "Spridgets" <spridgets@autox.team.net> |
Reply-to: | Larry Macy <macy@bblmail.psycha.upenn.edu> |
Sender: | owner-spridgets@autox.team.net |
>Larry, > >There's always the socket and hammer method... at the expense of the >socket however. Seriously, a large shop vise will pay for itself in no >time. >WFO Herb >Keep the sticky side down! > Quick update. I dropped the driveline, went to pull the circlips out of the yokes and immediately snapped one off. I took most everybodys advice - I took it to a shop. I should get it back tonight. Larry Larry Macy 78 Midget Keep your top down and your chin up Larry B. Macy, Ph.D. macy@bblmail.psycha.upenn.edu System Administrator/Manager Neuropsychiatry Section Department of Psychiatry University of Pennsylvania 3400 Spruce St. - 1015 Gates Philadelphia, PA 19104 |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Temperature Question 2, Michael Dietsche |
---|---|
Next by Date: | Re: Actually have Sprite question today (wasRe: slant six - was:oiladditives, Jim Rowan |
Previous by Thread: | Re: U-Joints, HFC |
Next by Thread: | 1500 Thrust Washer Check and Replacement Procedures, Michael Graziano |
Indexes: | [Date] [Thread] [Top] [All Lists] |