| To: | "Evangelos G. Makris" <emakris@hol.gr> |
|---|---|
| Subject: | Re: hub nut tool? |
| From: | HFC <froggi@cdsnet.net> |
| Date: | Wed, 02 Jun 1999 21:42:10 -0700 |
| Cc: | spridgets@autox.team.net |
| Organization: | WFO Racing |
| References: | <37505146.160D@hol.gr> |
| Reply-to: | HFC <froggi@cdsnet.net> |
| Sender: | owner-spridgets@autox.team.net |
1 7/8" I believe. And yes, one is LH thread. WFO Herb "Evangelos G. Makris" wrote: > Dear fellow Spridgeteers, > > could you please tell me what size tool (socket) is needed > to play with the hub nuts on the rear axle? > All I know is the LH one is LH-threaded and the RH one is > RH-threaded, am I right? > > Thanks > Evangelos |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Looking for feedback, Nory P |
|---|---|
| Next by Date: | Re: U-Joints, HFC |
| Previous by Thread: | Best Price on rear springs, Patton Dickson |
| Next by Thread: | Re: RH-LH, HFC |
| Indexes: | [Date] [Thread] [Top] [All Lists] |