Yup.
EXCEPT ... the radio is all the way back in the colsole.
All the way front, too.
chuck
Curtis Carlson wrote:
>
> Isn't there some way that you could add spacers between the radio and the
> console so that it fits farther back into the console? Seems to me that if
> this is possible, if you have space to move it back say an inch or so, that
> this would be the easier way to go.
>
> Curt
>
> Curtis Carlson
> '66 Austin Healey Sprite MkIII ("Gerty") HAN8L-63423
> ________________________
> Research Geographer 612.931.3936 (voice)
> Navigation Technologies 612.931.3937 (fax)
> 5780 Lincoln Dr Ste. 100 612.308.2595 (mobile)
> Edina, MN 55436 carlson@navtech.com
>
> ----- Original Message -----
> From: Chuck Ciaffone <chuckc@ibm.net>
> To: spridget list <spridgets@autox.team.net>
> Sent: Sunday, May 30, 1999 3:48 PM
> Subject: Fitting Car Radio Shafts ?
>
> > Now don't get me wrong, here. The radio has been in
> > for weeks now, and is doing just fine, thank you.
> >
> >
> > <rant>BUTTTTT ... because of the lack-of-depth in the console,
> > and the length of even the shortest modern car audio units,
> > With the mounting plate in place, the left and right threaded
> > shafts that mount the radio and that house the on/off/volume
> > and tuning shafts, stick way, way, WAY out (like an inch or
> > so) before terminating in the plastic knobs.
> >
> > whew! end of rant! </rant>
> >
> > Seems to me ... I should be able to shorten the threaded
> > tubes with a tubing cutter, and then "clip off" the control
> > "tangs" that are inside. In fact, seems to me didn't old
> > replacement radios came with shafts that were slightly
> > detented to be broken or cut off to shorten them?
> >
> > Anybody out there shed a little light on this? How to shorten
> > the tuning chafts on an auto radio?
> >
> > thanks,
> >
> > chuck
> >
|