All of your description is correct Bob, the foam pieces were not on my
original pockets, probably just another of moss's pawn jobs. There are two
pieces of thin material you will need as the provide a raised outline in the
door pocket panel. Some one on the list should have a spare set you could
talk them out of, Right guys???
Leo
-----Original Message-----
From: Bob Frato <bobfrato@bright.net>
To: spridgets@Autox.Team.Net <spridgets@autox.team.net>
Date: Monday, April 19, 1999 2:36 PM
Subject: Bugeye Door Pockets
>Can someone describe how the Bugeye Door pockets are constructed. My
>car never had any panels when I purchased it so I bought the Moss panel
>kit.
>
>I picked up a couple of doors from Carlisle (no reason to but cheap) and
>one of the doors had the panel on it. Had a curved metal top strip,
>masonite backing, cardboard cutout on top of masonite to make a recess,
>covered with vinyl, and rivited to the door (4 places). Is this the
>correct configuration?
>
>Second question - if the above is correct why are there two pieces of
>foam rubber the approximate shape of the door panel included with the
>kit - where do these go?
>
>Thanks,
>
>Bob Frato
>ahbugeye.com
>
>-got the rebuilt engine w/rear seal and tranny back finally just need to
>paint, put together and install and figure out how to time an engine all
>by May 2.
>
|