| To: | Dave_Vrba@mail.sel.sony.com, spridgets@autox.team.net, Metallian6@aol.com |
|---|---|
| Subject: | Re: Master cylinder question |
| From: | Ronsoave@aol.com |
| Date: | Thu, 8 Apr 1999 12:11:17 EDT |
| Reply-to: | Ronsoave@aol.com |
| Sender: | owner-spridgets@autox.team.net |
In a message dated 99-04-08 11:35:24 EDT, Dave_Vrba@mail.sel.sony.com writes: > Run taps through all the threaded holes to clean them out. Yup, good idea on all holes, and run a die over the bolts. This is especially important on anything torque critical, as the shmegma in the holes will give you a false toque reading on your wrench. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Master cylinder question, Peter C. |
|---|---|
| Next by Date: | RE: Soft Top questions..., Phil Vanner |
| Previous by Thread: | Re: Master cylinder question, Larry Miller |
| Next by Thread: | Re: Master cylinder question, LBCarNut |
| Indexes: | [Date] [Thread] [Top] [All Lists] |