Mark,
I had the same problem with the clips that came from VB with the cylinder. I
went down to my local Ace Hardwear store and bought one the same size but it
was a little thinner. Therefore it was easier to pop right on. The original
was just too stiff and unflexible.
Dick Watson
-----Original Message-----
From: Mark Snowdon <racer45@bellsouth.net>
To: spridgets@autox.team.net <spridgets@autox.team.net>
Date: Thursday, March 25, 1999 5:50 PM
Subject: Help!! No not the Beatle's song
>I am replacing the wheel cylinders on our 69 Sprite, and can't get the
>$%#%^$& c clip in behind the cylinder, in order to hold it onto the
>backing plate. Is there a trick to doing these clips. Should i be
>inserting the center of the clip in the groove or the tips and then
>cramming the center down, or what. Please help...
>
>Mark Snowdon
>Greensboro NC
>
|