In a message dated 15/3/1999 5:25:54PM, millerls@ado13.com writes:
<< Turn the key on and the gas gauge works. Start the engine and the gauge
goes
to full and stays there until the engine is turned off.
If you pull the coil hot wire so the engine will not start and crank the
engine, the gauge moves to full while the starter is turning. As soon as you
stop cranking, the gauge goes back to where it should be.
All thoughts appreciated.
>>
Might need a new voltage stabiliser unit - the little metal box with 2 wires
attached that you never knew the purpose of.
Daniel1312
|