About baking paint-Sometimes the problem with paint not adhering well after
baking is the part itself. On some parts heating it up will release gases or
other materials absorbed into the metal itself over the years. Simple
surface cleaning of the part doesn't get the embedded stuff out but heating
will release this stuff and break the bond of the paint.
Jon
per Steve Byers...
>>>I have baked many parts using only Plastikote engine enamel without any
>>>primer at all, and never had a failure of the finish.
>
> And Steve's paintwork really looks sharp too!
> Ed in NC :-)
> (Hi Steve and Frieda!)
>
|