Finished the gas tank installation, gas line installation, fuel pump
installation, and wiring to the pump today. Set the timing and it fired
right up. New oil/water temp gauge seems to work but the amp gauge acts a
little strange. Have to check the wiring and see what's going on, remember I
made the wiring harness myself.
Solved the wheel bearing dilemma at least for now. I tightened the castle
nuts to the correct torque, backed off until it felt right, and ran a drill
through the holes in the axle so I could get the pins in.
Now all I need to do is bleed the brakes and clutch, recheck all suspension
bolts, oil the tranny, and go for the first test drive....All the wheels
will probably fall off when I go around the first corner.
I may get to try it on the road next weekend...MY SO has plans for me
tomorrow.
Larry Miller
|