In a message dated 99-01-20 10:45:06 EST, rcarlson@csw.com writes:
<< I need to locate any documentation/advice on the workings of the horn in
the
bugeye. I have tried to install the horn push with a repro plunger, but it
appears as if the plunger is too wide. I also have tried an original plunger
and it also appears too long. There has to be something that I'm missing.
>>
Rob,
There is something missing here. The plundgers avail. from Moss etc. are
(believe it or not) actually pretty good in size fit etc. I did find however
that I did have to file the plunger diameter down a bit as one I had wass too
thick for the hole in the steering wheel. Better to rework the plunger at
$6.00 than drill a bigger hole in your steering wheel. Didn't have to take
too much off the diameter of the plunger though.
george marinos
sprite MKII AN6
glen rock, nj
|