>Ajhsys@aol.com wrote:
>
>>
>> Let's try to stick to EXPERIENCE. No more opinions. What do you have,
how
>> did you like installing them, and how are they holding up. Did you have
any
>> particular problems with them.
I bought steel in 5 ft lengths at the local Advance Auto store. I borrowed
a friend's bubble or double flare tool reused the old fittings (they were
fine) and all came out well. Used a loaner car's pipes as a pattern (my
car's were not run in the right way -- they actually came in front of the
heater box!?!) Made the bends using my two thumbs except for the coil in
the line going down to the slave cylinder. I used a 2 inch pipe for that.
I am happy with the results and the cost was about $15.
Jeff Church
|