Larry,
I was successful with a propane torch to heat the bearing ring and then
chiseling to move it.
Ulix
On Fri, 11 Dec 1998, Larry and Sandi Miller wrote:
> I've been playing around with the roller wheel bearings trying to get them
> to fit. I've tried them with and without the spacer and no go. They will not
> go on far enough to insert the cotter pin and the outer brake pad will not
> go in.
>
> So far all I've succeeded in doing is getting the inner bearing stuck on the
> axle. Any thoughts on getting it off other than a dremal?
>
> The swivel axles are new. Every part on the front is new except the hub.
>
> Below are the parameters for the various stock and possible Timken's. I'm
> using the 07097/05066 combo.
>
> Inner Bore OD Width (Thickness)
> Stock .9843 2.0472 .5905
> 30205 .9843(0) 2.0472(0) .6398(+.049)
> 07097 .9843(0) 2.0470(-.0002) .5910(+.0005)
>
> Outer Bore OD Width (Thickness)
> Stock .66929 1.8504 .55118
> 30303 .6693(+.00001) 1.8504(0) .6004(+.04922)
> 05066 .6690(-.00029) 1.8504(0) .5662(+.01502)
>
> Larry Miller (larry@ado13.com)
> 60 Bugeye (At The "All It Takes Is Money" To Finish Stage)
> 59 Bugeye "BUGIIIS" (Undergoing a body transplant)
> 78 911 SC (Faster than a Bugeye but not as much fun)
> Home Page http://www.ado13.com
>
>
>
Ulix __/__,__
.......................................................... (_o____o_)....
'67 Sprite
|