| To: | "Sprite List" <spridgets@Autox.Team.Net> |
|---|---|
| Subject: | Dumb Question |
| From: | "Jeff Church" <jchurch@exis.net> |
| Date: | Sat, 6 Dec 1997 16:26:43 -0500 |
| Reply-to: | "Jeff Church" <jchurch@exis.net> |
| Sender: | owner-spridgets@Autox.Team.Net |
Ok guys, its been a while for me. When installing a new valve cover gasket, does one use anything other than a little engine oil to seal it? Also, my valve cover vent tube has no where to go. I have a DOCE sidedraft Weber with a nice K&N air filter. Alas, the K&N has no inlet tube on its back panel to accept a tube from the valve cover vent. Am I mucking things up by going without this arrangement? If so, any suggestions? Jeff Church |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Suppliers, Rick / Carolyn Walters |
|---|---|
| Next by Date: | Re: 1275 cc Engine Disassembly, Frank Clarici |
| Previous by Thread: | Dumb Question, Larry and Sandi Miller |
| Next by Thread: | Re: Dumb Question, Frank Clarici |
| Indexes: | [Date] [Thread] [Top] [All Lists] |