The bolt circle (pcd in the UK) is 4-on-3.75" - the 3.75" is measured
from the center of one stud hole to the center of the opposite stud
hole. I think the center hole needs to be 2.25" (from memory, check a
stock wheel to be sure).
You'll want a small positive offset (10-15mm, probably) - large
positive offset wheels (35-45mm) are for front wheel drive cars or use
with 1" thick adapters. Negative offset will give it a low-rider look
(wheels stuck way outside the fenders).
M D "Doc" Nugent
Renton, WA *USA*
--- Grant & Cheryl <buss3@rogers.com> wrote:
> I am on the hunt for some Panasport wheels for my '78 Spitfire. I
> know I want
> 13' X 5.5' but what are the other sizes? Offset? Bolt hole spacing?
> I still have stock breaks etc.
Tired of spam? Yahoo! Mail has the best spam protection around
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|