See "the nut method" about halfway down this page:
http://www.thebugshop.org/gotech.htm
M D "Doc" Nugent
Renton, WA
--- Ed Hamilton <h_edward@bellsouth.net> wrote:
> OKIt started as a very simple job to remove the
> screws from the door latch
> assemblys in the door jams. As it turns out the <
> Phillips head screws
> were installed with a thread locking compound. I
> had to drill through the
> center of the screw and remove them with a screw
> extractor.
>
> While doing the last one, the extractor broke flush
> in the hole. Now, I
> have to drill out the extractor, which is extremely
> hardened steel. I do
> not have a bit (in my tool box) that will begin to
> cut through this
> material.
>
> Would greatly appreciate any suggestions.
>
>
>
> Regards,
>
> Ed Hamilton
__________________________________
Yahoo! SiteBuilder - Free web site building tool. Try it!
http://webhosting.yahoo.com/ps/sb/
|