Bill,
Joe's right about the un-even mixture distribution. Go
to:
http://www.vtr.org/maintain/spit-carbs/topview.html
to see a picture illustrating this. If you haven't got
some
dimensions yet, email me and I'll measure my manifold for
you.
Joe Curry wrote:
[...]
> So If you do build a manifold for a single DCOE, be
sure to take into
> consideration the balance of the tubes.
Bill Miller wrote:
[...]
>> I am in the process of making an intake manifold for a
single Weber
>> sidedraft. As the price for the carb from the
importer is <$250, I figure I
>> can make a good stainless steel intake for it and not
spend *too* much for
>> the whole package.
--
Stan Part
"International Lawn Tractor Racer"
|