>I'm looking for the trim that covers the weld flange on the bottom edge
>of the quarter panels, which apparently welds in place instead of using
>clips like the rest of the trim uses. (Or perhaps the spot welds are a
>DPO bodge of some sort, but it looks original
*************************************
John,
Check with John Kipping in the UK. That's where I purchased mine for the
Spitfire project. Rimmer Bros. also lists it. It a Finisher - wing lower,
part number 715821 for the square tail - and 706600 for the round tail
version. Yes it is welded in place but only in a few places. A couple
spots near each end, just enough to hold them on.
Barry Schwartz (San Diego) bschwart@pacbell.net
72 V6 Spitfire (daily driver)
70 GT6+ (when I don't drive the Spit)
70 Spitfire (project)
73 Ford Courier (parts hauler, rain vehicle, getting a V6 soon!)
|