I was describing the gen2 clips. A few years back I purchased 12 from a dealer
for $6.
A 75-90 degree circlip tool works perfectly, and can be had at most autoparts
stores for about $5.
I remember my 93 sable had slightly different clips from my 95 SHO. The earlier
clips put pressure on the plastic shaft, but you could pull up by grabbing the
top of the clip and they would slide off. The SHO has indentations around the
shaft, and the clips "snap" into these indentations. You MUST use a tool to
pull the "arms" of the clip out of the indentations on the shaft, or you will
likely bend and/or break off the arms.
Not that the arms matter much. Gravity tends to keep the clips in place without
them.
David
-----Original Message-----
>From: Sean Simons <sisimons@gmail.com>
>Sent: Jun 26, 2006 4:27 AM
>To: shotimes <shotimes@autox.team.net>
>Subject: Re: [Shotimes] Removing headlights
>
>The 2nd Gen cars may use a different type of clip (judging from the
>hyper-accurate Chilton book), but my 89 was exactly as you described, with
>the little holes that you have to separate on the clips. I still haven't
>found a good tool to remove them with. Also, I've broken many of them while
>removing them, but I've made my own versions cut out of 1-2 mm scrap
>plastic. They don't have the little fingers that prevent them from sliding
>out, but so far friction has held them in just fine. They're much easier to
>remove with regular pliers.
>
>Sean
>
>On 6/25/06, Christina CASSELTON <silversho95@msn.com> wrote:
>>
>> It is a good idea to have replacement clips for these before you attempt
>> this
>> job though because they usually break upon removal. BTDTHTTS
>>
>> C
>> ----- Original Message -----
>> From: FlamingTaco<mailto:flamingtaco@earthlink.net>
>> To: shotimes@autox.team.net<mailto:shotimes@autox.team.net>
>> Sent: Sunday, June 25, 2006 12:14 PM
>> Subject: Re: [Shotimes] Removing headlights
>>
>>
>> On he back of the headlamps there are three mounting points. Each mount
>> has
>> a metal clip that retains the headlamp. Pull the metal clips up and out,
>> and
>> you can remove the headlamp by pulling forward. A pair of angled ring
>> pliers
>> works best as there are two holes towards the bottom of the clips for
>> pulling
>> the clips apart to disengage them from the mount.
>>
>> David
>>
>>
>> -----Original Message-----
>> >From: Maury Alston <freeze_0387@yahoo.com<mailto:freeze_0387@yahoo.com
>> >>
>> >Sent: Jun 25, 2006 12:27 PM
>> >To: shotimes@autox.team.net<mailto:shotimes@autox.team.net>
>> >Subject: [Shotimes] Removing headlights
>> >
>> >Hey everybody,
>> >
>> > Can someone forward me the instructions on how to remove the
>> headlights
>> on a 92 MTX? I want to, as someone put it, apply great amounts of seal to
>> them.
>> >
>> >
>> > Maury
>> > 92 MTX-Shonuf
>> >
>> >
>> >---------------------------------
>> >Want to be your own boss? Learn how on Yahoo! Small Business.
>> >_______________________________________________
>> >Shotimes mailing list
>> >Shotimes@autox.team.net
>> >http://www.team.net/mailman/listinfo/shotimes
>> _______________________________________________
>> Shotimes mailing list
>> Shotimes@autox.team.net<mailto:Shotimes@autox.team.net>
>> http://www.team.net/mailman/listinfo/shotimes<
>> http://www.team.net/mailman/l
>> istinfo/shotimes>
>> _______________________________________________
>> Shotimes mailing list
>> Shotimes@autox.team.net
>> http://www.team.net/mailman/listinfo/shotimes
>_______________________________________________
>Shotimes mailing list
>Shotimes@autox.team.net
>http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|