There are tens of millions of these in use all over, and I expect that
none of them have an equipment grounding conductor. There doesn't
seem to be any widespread problem...
Just make sure to use a polarized plug (check your house wiring if
necessary), and exercise due care when wiring the socket. (Hot wire
to the center, neutral to the shell, but you knew that.)
I have been known to solder the bare conductors in a hook shape so no
strands go awry when I tighten the screw - but even that is probably
overkill.
Jeff Scarbrough
Corrosion Acres, Ga.
On Sat, Aug 20, 2016 at 2:01 PM, Jim Franklin <jamesf@groupwbench.org> wrote:
> I'm rewiring an old lamp and the engineer in me says I should ground the
> frame in case the socket goes awry. There's currently no conductivity between
> the neutral part of the socket and the frame/pole (isolated by a cardboard
> sleeve), so if the hot touches the frame it will become hot.
>
> Paranoid or common sense? Any reason not to?
>
> thanks,
> jim
> _______________________________________________
>
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/shop-talk/fishplate@gmail.com
>
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/archive
|