Wayne,
I just found a wiring diagram on the net and see that the connector i
was looking at was for the lights only, and not the CAN-bus module.
There is another 12-pin connector that I didn't see that I need to wire
up some of the pins on to get it to work. The original console I have
only contains reading lights, while the one I am installing has the trip
computer, etc., a totally separate module, in addition to the lights.
Thanks for your reply.
Peace,
Pat
Thusly spake Wayne
> Are you sure it needs more wire? CAN-Bus has been common for nearly 20
> years now, and cars blip network packets over power conductors, rather
> than running separate conductors for every device. Even if it was
> hard-wired, I doubt they would have two different harness stocked on a
> 'line just for one optional feature.
>
> -w
>
> On 11/10/2012 6:21 PM, Pat Horne wrote:
>> My 2006 Caravan is sitting in my shop and I am trying to replace the
>> overhead lighting console with one that has the trip computer in it. I
>> have all the mechanical parts needed, just need to run one wire to it.
>> Anyone have a wiring diagram or at least color code for the one extra
>> wire I need to run? I assume it runs to one of the circuits in the OBD
>> II connector, but can't find anything on line about it.
>>
>> Thanks in advance.
>>
>> Peace,
>> Pat
> _______________________________________________
>
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/shop-talk/pat@hornesystemstx.com
>
>
>
Pat Horne, Owner, Horne Systems (512) 797-7501 Voice & Text 5026 FM 2001
Pat@HorneSystemsTx.com Lockhart, TX 78644-4443 www.hornesystemstx.com --
We support Habitat for Humanity - a hand UP, not a hand OUT --
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/archive
|