I just bought new sleeves and it still won't thread straight. Threads on
the rod end are not crossed...WTF am I going wrong?
On Sat, Sep 29, 2012 at 1:45 PM, ejrussell@mebtel.net wrote:
> Quoting Tim <tputland@charter.net>:
>> Is there a trick to getting a new tie rod into the adjustment sleeve?
>> I
>> cannot, for the life of me, get the new tie rod end to start
>> threading
>> straight. It goes crooked on the first turn, everytime time.
>
> You likely need to 'chase' the threads. Once cross-threaded it will
> tend to follow that thread each time you try to assemble it (and get
> worse each time, too). Best would be to get a re-threading tap/die -
> less chance of cutting new (incorrect) threads. This is assuming the
> new part has the correct threads. Will the old tie rod thread back on
> OK?
>
> Eric Russell
> Mebane, NC
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/archive
|